PSD Service Instructions
PSD09, PSD10 or PSD12 Style
PSD08 Style
5 If replacing safety, using the plastic handle on the safety filter, slide the filter at an angle into the outlet side and push in place until the filter seats firmly and evenly within the housing. Note: On PSD09, PSD10 and PSD12 models, insert the safety filter tab into the positioning slot before pushing the filter in place.
Plastic Handle
Safety Filter Positioning Tab Location
6 Insert the primary filter. For PSD08, slide the filter into the housing until the gasket seats against the housing. For PSD09, PSD10 and PSD12, slide the filter down at approximately a 5° angle until it hits the end of the housing. Rotate the filter toward the outlet section to complete the seal. 7 Replace the service cover. On PSD08, tilt the service cover into place and secure latches. For the PSD09, PSD10 and PSD12, placed the service cover in position and fasten the latches. Note: If the cover doesn’t seat, remove and re-check the filter position. The cover will be difficult to install if the filter isn’t installed correctly.
8 Visually inspect your inlet and outlet connections. If your air cleaner has a Vacuator Valve, inspect the valve. Replace if any signs of wear or damage are visible.
Engine Air Cleaners, Accessories & Service Parts n 35
Powered by FlippingBook