Donaldson Engine Air Filter Catalogue

DuraLite™ ECB, ECC, ECD Service Instructions

Service Recommendations

Servicing Intervals Choose either of two types: • Scheduled maintenance.

Service Indicator Location For proper restriction readings, a restriction fitting tap must be located between the engine intake and DuraLite outlet neck. The tap should be located in a straight section of the intake pipe at least one pipe diameter away from the manifold or any bends, elbows or reducers. Servicing Tips • Do NOT judge the filter on the basis of visual inspection! If it's doing its job, it should look dirty. DuraLite filter life is longer than you may think. Change the filter only when restriction readings indicate. • Do NOT leave the inlet ducting exposed any longer than necessary (a few minutes) during service.

DuraLite service intervals can be integrated into any existing maintenance program. • Restriction Maintenance. This method offers the most accurate filter maintenance program, delivering maximum filter life at 99.9% efficiency, less machine downtime, and reduced maintenance costs. • Washing, cleaning or servicing the filter in any way voids the warranty.

Disposal Normal trash pick up is acceptable - never burn.

Installation Instructions

Installation DuraLite air cleaners can be mounted in two ways: 1. Direct Mount: mounted directly on the intake manifold. 2. Remote Mount: mounted away from engine and connected to engine with inlet piping. Installation Tips • Engage outlet neck of the DuraLite™ over intake piping for a full 38 mm to insure a secure, lasting seal. • Tighten clamp around outlet neck to 0.7 daNm minimum. A Donaldson high torque hose clamp is recommended. • On remote mount style, avoid crushing the body with body clamps. A snug fit is best, and body clamps are not always required. • Keep away from engine manifold and other very hot components (DuraLite™ is rated at 83°C maximum sustained temperature). • Keep away from battery acids, brake fluid, and other caustic fluids.

Torque clamp to 0.7 daNm (minimum)

38 mm

Torque clamp to 0.7 daNm (miminum)

38 mm

42 n Engine Air Cleaners, Accessories & Service Parts

Powered by